. OPERATION OPERATION 3 - 62 CHECK CENTRAL WARNING LA MP to prevent failure by the warning Carry out the following checks system due to defective operatio in central warning lamp (1). I n of the buzzer or blown lamp bulb f any abnormality is found, ask Komatsu distributor for inspecti Stop the engine, turn the star on. ting switch to the ON position, set the parking brake valve leve r to the PARKING position, move the shift lever to any position o ther than N, and check. If the lamp flashes and buzzer sounds, i t is normal. the specified pressure, the lamp If the air pressure is below should flash and the buzzer switch is turned ON.
should sound when the starting CHECK BRAKING EFFECT Check if the braking capacity of the parking brake, foot brake, and If any abnormality is found, ask CHECK MACHINE MONITOR SY STEM urn the starting switch to the ON position. 1. Before starting the engine, t 2. Check that all monitor lamp alarm buzzer sounds for ap . Before starting the engine, t urn the starting switch to the ON p . Check that all monitor lamp s, gauges, and the central warning lamp light up for approx. 3 seconds and that the prox. 1 second. REMARK dometer should display 88.
When this is done, the spee When the starting switch is t urned to the ON position, the pilot lamp at the transmission shift lever position wil flash if the shift lever is not a t the N position. When the shift lev er is moved to the N posit ion, N is displayed. e passed. After the engine is stopped, t he monitor cannot be checked unt il at l east 30 seconds hav . When checking the monitor , check for blown bulbs in the the caution lamps and pilot lamp the engine, turn the starting bulb check switch (1), and c lamp bulb is blown. If the monitor lamp, caution there is probably a failure o your Komatsu distributor for s at the same time.
Before starting switch to the ON position, press heck that no caution lamp or pilot lamp, or pilot lamp do not light up, r disconnection, therefore contact inspection.