Yanmar — 4.3.2 Reassembly

4. Disassembly and reassembly 4.3.2 Reassembly (1) Clean all parts Clean all parts using by the cloth and diesel oil (or cleaning agent) before reassembly. NOTE: 1) If the dust remain with the parts, engine may cause the seizing or damage. 2) The cleaning agent removes even carbon adhering to disassembled parts. (2) Putting the cylinder block upside down Place a wood block on the floor and put the cylinder block upside down (with the cylinder head mounting surface facing down). (3) Inserting the tappets Coat the inside of the cylinder block tappet holes and the outside circumference of the tappets with engine oil, and insert the tappets in the cylinder block. NOTE:

Separate the tappets to make sure that they are reassembled in the same cylinder No. and intake/ exhaust side as they came from. (4) Mounting the crankshaft 1) The crankshaft and the crankshaft gear are shrink fitted. If the crankshaft and the crankshaft gear have been disassembled, they have to be shrink fitted [heat the crank shaft gear to 180- 200 deg. C in the hot oil and press fit to the crankshaft]. 2) Coat the crank journal part of the cylinder block and the upper main bearing metal with oil and fit the upper main bearing metal onto the cylinder block. NOTE: 1) Be sure not to confuse the upper and lower main bearing metals. The upper metal has an oil groove.

2) When mounting the thrust metal, fit it so that the surface with the oil groove slit faces outwards, crankshaft side. Cylinder block Crankshaft 3) Coat the crankpins and the crank journals of the crankshaft with engine oil and place it on the upper main bearing metals. Thrust metal NOTE: 1) Position so that the crankshaft gear is on the gear case side. 2) Be careful not to let the thrust metal drop. Main bearing (Base) Main bearing Main bearing bolt (Removing main bearing and crankshaft) 89