4. Disassembly and reassembly (5) Mounting the main bearing cap Coat the lower main bearing metal with engine oil, and mount it to the main bearing cap. Upper main bearing metal Oil hole NOTE: 1) The lower main bearing metal does not have an oil hole. 2) The base bearing thrust metal is fitted with the oil groove facing outwards. 1) Coat the flange and the thread of the main bearing bolts with engine oil, put them on the crankshaft journal, and tighten the main bearing bolts to the specified torque. Lower Thrust metal Groove Main bearing cap Tightening torque N•m (kgf•m) NOTE: 1) The main bearing cap should be mounted with the arrow on the cap pointing towards the flywheel.
2) Make sure to have the correct cylinder alignment number. 2) Measure the crankshaft side clearance. Mark mm Positioning number of reassembling 3) Make sure that the crankshaft rotates smoothly and easily. (Journal bearing cap) (6) Mounting the flywheel housing 1) Replace the used oil seal with new one. Press fit the oil seal in the flywheel housing, and coat the lip of the oil seal with engine oil. 2) Apply the liquid gasket on the mounting surface of the flywheel housing and mount the flywheel housing to the cylinder block, while matching up with the knock pins. 9 7 7 7 7 0 - 0 1 2 1 2 Knock pin (two) NOTE:
Be careful that the liquid gasket does not protrude onto the oil pan mounting surface. Flywheel housing Liquid gasket Oil seal Cylinder block 90 Main bearing bolt 75.5-81.5 (77-8.3) Crankshaft side clearance Standard Limit 0.133-0.233 0.28