Yanmar — 4.3.2 Reassembly

4. Disassembly and reassembly (7) Turning the engine over Stand up the engine on the flywheel housing. Cylinder block Flywheel housing (8) Mounting the gear case Apply the liquid gasket to the gear case and mount the gear case and lube oil line O-ring onto the cylinder block. NOTE: 1) When mounting the gear case, match up the two knock pins of the cylinder block. 2) Be sure to coat the O-ring for the cylinder block lube oil line with grease when assembling, so that it does not get out of place. (9) Mounting the piston and connecting rod 1) Reassemble the piston and connecting rod. Make the punched manufacturer's mark face upward. NOTE:

1) When reassembling the piston and connecting rod, make sure that the parts are assembled with the correct orientation. 2) Install each piston ring on the piston, with the punched manufacturer’s mark facing upward. 3) The piston ring joints shall be staggered at by 120 ° intervals. Do not position the top ring joint vertical to the piston pin. The coil expander joint shall be opposite to the oil ring joint. (Piston ring) Oil ring joint 120 120 Second ring joint 120 Top ring joint Expander joint (Ring joints) 91R1