Yanmar — 4.3.2 Reassembly

4. Disassembly and reassembly 2) Coat the outside of the piston and the inside of the connecting rod crank pin metal with engine oil and insert the piston with the piston insertion tool. Piston ID mark NOTE: 1) Insert the piston so that the match mark on the large end of the connecting rod faces the fuel nozzle, and the manufacture’s embossed mark on the stem faces toward the flywheel. 2) After inserting the piston, make sure the ID mark on the piston top is located at the camshaft side, looking from the top of the piston. 3) Align the large end match mark, mount the cap, and tighten the connecting rod bolts. Camshaft side Nozzle side Tightening torque N•m (kgf•m) NOTE:

If a torque wrench is not available, match up with the mark made before disassembly. Embossed mark (Flywheel side) (10) Mounting the camshaft 1) If the camshaft and the camshaft gear have been disassembled, shrink fit the camshaft and the camshaft gear [heat the camshaft gear to 180-200 deg. C in the hot oil and press fit]. NOTE: When mounting the camshaft and the camshaft gear, be sure not to forget assembly of the thrust metal. Also make sure they are assembled with the correct orientation. 2) Coat the cylinder block camshaft bearings and camshaft with engine oil, insert the camshaft in the cylinder block, and tighten the thrust metal bolts. 3) Measure the camshaft side gap.

Camshaft gear Thrust metal 4) Make sure that the camshaft rotates smoothly. Side gap (Camshaft side gap) 92R1 Connecting rod bolt 22.6-27.5(2.3-2.8) mm Camshaft side gap Standard Limit 0.05-0.15 0.25