5. Inspection and servicing of basic engine parts 5.5 Crankshaft and main bearing The crank pin and crank journal have been induction hardened for superior durability, and the crankshaft is provided with four balance weights for optional balance. The crankshaft main bearing is of the hanger type. The upper metal (cylinder block side) is provided with an oil groove. There is no oil groove on the lower metal (bearing cap side). The bearing cap (location cap) of the flywheel side has a thrust metal which supports the thrust load.
Balance weight Crank shaft Crank shaft gear Main bearing metal (basic) Thrust metal Main bearing metal (intermediate) Main bearing cap (basic) Main bearing bolt Main bearing cap (intermediate) Main bearing bolt 5.5.1 Crankshaft (1) Color check after cleaning the crankshaft, and replace the crank shaft if there is any cracking or considerable damage. (Inspection by color check) (2) Bending of the crankshaft Support the crankshaft with V-blocks at both ends of the journals. Measure the deflection of the center journal with a dial gauge while rotating the crankshaft to check the extent of crankshaft bending.
The total indicating reading on the dial gauge is divided by two to obtain the crankshaft bend. Bend mm Deflection Dial gage V-block V-block (Crankshaft bend measurement) 125R1 Crankshaft bend limit 0.01