Yanmar — 5.5.1 Crankshaft

5. Inspection and servicing of basic engine parts (3) Measuring the crank pin and journal Measure the outside diameter, roundness and taper at each crank pin and journal. Correct by grinding if unevenly wear, roundness exceeding the limit or insufficient outside diameter is found. Replace if the defect is excessive. mm To look for the oil clearance of crank pin, measure the inside diameter of crank pin metal. (Refer to 5.4.2(2).

) mm Crankshaft journal Crank pin Measuring position of the crank pin and crank journal ) ( Super polishing Dimension R and finishing precision of crankshaft journal and pin Super polishing Thrust face Ry=0.8S As for grinding processing of journal and pin, machine it by using the grinding wheel of the dimension R of below table. Ry=0.8S R R R Surface finishing precision standard on journal and pin: R R Crank Pin (Crankshaft R machining) Crank Journal Ry = 0.8S super polishing Surface finishing precision standard on the thrust side 1.6 of crankshaft arm : Finishing precision standard of dimension R (mm) 3.5+0.3/0 NOTICE:

1) lf the oil clearance is excessive though the thickness of the journal and crankpin metals are normal or if partial uneven wear is observed, re-grind the crankshaft and use an undersize metals. 2) lf rust or surface roughening exists on the rear side of the metals, coat it with blue or minimum. Then assemble the crankpin metal to the connecting rod, and tighten the rod bolt to the specified torque to check the metal for contact. lf the contact surface occupies 75% or more, the metal is normal. lf the contact surface is insufficient, the metal interference is insufficient. Replace the metal with a new one.

126R1 Item Standard (Diameter) Limit (Diameter) Roundness Taper 0.01 or less 0.02 Standard Limit Crank pin 3YM30 Outside dia. 41.952-41.962 41.902 Oil clearance 0.020-0.058 0.120 Crank pin 3YM20/2YM15 Outside dia. 37.952-37.962 37.902 Oil clearance 0.020-0.058 0.120 Crank journal (Selective pair) All models Outside dia. 46.952-46.962 46.902 Oil clearance 0.020-0.050 0.120