Yanmar — 5.5.2 Main bearing

5. Inspection and servicing of basic engine parts (4) Checking the side gap of a crankshaft After assembling the crankshaft, tighten the main bearing cap to the specified toque, and move the crankshaft to one side, placing a dial gauge on one end of the shaft to measure thrust clearance. Replace the thrust bearing if it is worn beyond the limit. mm (Side gap measurement 1) 001544-00E Other measurement method can also be effective. Insert the thickness gauge directly into the clearance between the thrust metal and crankshaft thrust face.

Cylinder block Crankshaft Standard width Thrust metal face Thrust Bearing cap Thickness gauge (Side gap measurement 2) 5.5.2 Main bearing Flywheel side (1) Inspecting the main bearing Check for flaking, seizure or burning of the contact surface and replace if necessary. Block side main bearing metals Cap side main bearing metals (2) Measuring the inner diameter of metal Tighten the cap to the specified torque and measure the inner diameter of the metal. Thrust metals Gear side N•m (kgf•m) Main bearing bolt (Main bearing) NOTE: When assembling the bearing cap, keep the following in mind. 1) The lower metal (cap side) has no oil groove. 2) The upper metal (block side) has an oil groove.

3) Check the cylinder block alignment number. 4) The “FW” on the cap lies on the flywheel side. Mark Positioning number of reassembling (Journal bearing cap) 127R1 Standard Limit Crankshaft side gap 0.111-0.250 0.30 Tightening torque 75.5-81.5 (7.7-8.3)