9. Cooling water system 9.5.4 Replacing filler neck 1) Take out the copper pipe inside the filler neck with striking a circumference with a driver and so on. When the filler neck is removed, remove it with being careful not to damage the fresh water cooler, and scrap it. 2) Clean both new filler neck and the insertion part of fresh water cooler. Apply T7471 type activator or equivalent on both the surfaces and let it evaporate. 3) Apply Loctite 603 (improved 601) glue or equivalent on filler neck outside contour and press the filler neck into the fresh water cooler with the special tool.
Tool 1 Tool 1 Tool 1 Filler neck Filler neck Filler neck 4) To fix the filler neck on the fresh water cooler, press the small copper tube inside the filler neck with the special tool. Note: The top of this tube should be under the sealing surface of the filler neck for the pressure cap. 5) Fit the pressure cap on the filler neck. Refer to 4.2.2 for tool 1 and tool 2. 167 Tool1 Press the filler neck Filler neck Fresh water cooler Loctite 601 Tool2 Press the copper tube in the filler neck Copper tube Filler neck Part No. Copper tube Part No. 129673-44110 129673-44150