9. Cooling water system 9.5.5 Function of the coolant recovery tank Coolant recovery tank Filler cap The pressure valve opens to discharge steam when the steam pressure in the fresh water tank exceeds 90 kPa (0.9 kgf/cm 2 ). This consumes water. The coolant recovery tank maintains the water level by preventing this discharge of water. The steam discharged into the coolant recovery tank condenses into watch, and the water level in the tank rises. When the pressure in the fresh water system drops below the normal value, the water in the coolant recovery tank is sucked back into the fresh water tank to raise the water back to its original level.
The coolant recovery tank facilitates long hours of operation without water replacement and eliminates the possibility of burns when the steam is ejected from the filler neck because the pressure cap does not need to be removed. 30 mm 8 9 20.5 130 65 25 70 35 FULL LOW 60 61 120 9.5.6 Specifications of coolant recovery tank 9.5.7 Mounting the coolant recovery tank (1) The coolant recovery tank is mounted at approximately the same height as the heat exchanger (fresh water tank). (allowable difference in height : 300 mm (11.8110 in.) or less) (2) The overflow pipe should be less than 1000 mm (39.3701 in) long, and mounted so that it does not sag or bend. NOTE :
Make sure that the overflow pipe of the coolant recovery tank is not submerged in bilge. If the overflow pipe is submerged in bilge, water in the bilge will be siphoned into the fresh water tank when the wafer is being cooled. Mounting plate Overflow tube Sub tank 9.5.8 Precautions on usage of the coolant recovery tank (1) Check the coolant recovery tank when the engine is cool and refill with fresh water as necessary to bring the water level between the low and full marks. (2) Check the overflow pipe and replace if bent or cracked. Clean out the pipe if it is clogged up. 168 Capacity of coolant recovery tank Overall capacity 1.3 L Full-scale position 0.8 L Low-scale position 0.2 L