Yanmar — 2.2.7 Inspection every 1,000 hours or four years

2. Inspection and adjustment (5) Diaphragm assembly inspection Inspect the diaphragm assy on the rocker arm cover. 1) Loosen screws, and remove a diaphragm assembly, and check whether oil and so on doesn't enter between the diaphragm and the cover. If oil and so on enters into the diaphragm assy, the diaphragm doesn't work well. 2) Check the damages of the diaphragm rubber and the spring. If necessary, replace with new ones. Diaphragm cover Spring Center plate Diaphragm Rocker arm cover Breather baffle [Notice] 1) When a diaphragm is damaged, pressure control inside the crankcase becomes insufficient, and troubles such as combustion defect and so on occur.

2) At lube oil replacement or lube oil supply, the amount of lube oil isn't to be beyond the standard upper limit. If the lube oil quantity is beyond the upper limit or an engine is operated beyond the allowable maximum angle of an engine, the amount of oil mist may be inducted in the combustion chamber and the oil hammer sometimes may occur. Baffle plate Intake manifold (Breather system component) (6) Adjust the tension of the alternator driving belt Replace the alternator driving belt with new one every 1000 hours or four years, whichever comes first, even if there is no crack in the surface. Refer to 2.2.2(4) for the procedure. (7) Retighten all major nuts and bolts.

Retighten the major nuts and bolts bellow by the standard tightening torques. (See the table in 4.5.) 1) Cylinder head bolts 2) Crankshaft pulley bolts 3) Fuel injection nozzle set bolts 4) Fuel pump gear set bolts 5) Fuel injection line sleeve nut Retighten the following major bolts as requested. 1) Rod bolts 2) Flywheel set bolts 3) Metal cap bolts (8) Adjust intake/exhaust valve clearance. Refer to 2.2.2(5) for the procedure. (9) Check/adjust the remote control operation. Refer to 2.2.2(6) for the procedure. (10) Adjust the propeller shaft alignment. 1) The rubber tension of the flexible engine mounts is lost after many hours' use.

This leads to a drop in vibration absorption performance, and also causes centering misalignment of the propeller shaft. (Refer to 5. "Flexible Engine Mount" in the installation manual for pleasure boat use.) [Notice] Be sure to replace the Yanmar flexible engine mounts every 1000 hours or 4 years, whichever comes first. 2) After replacing the flexible engine mounts, check unusual noise and vibration of the engine and the boat hull with increasing the engine speed gradually and lowering it. 3) If there is unusual noise and/or vibration, adjust the propeller shaft alignment. (Refer to 6.4.5 "Centering the Engine" in the installation manual for pleasure boat use.) 43