OM4204 Maintenance - Section 42 Automatic Lubrication System Page 42-5 SYSTEM CHECKOUT The automatic lubrication system may be manually activated using the Manual Lubrication Switch (2, Figure 42-6) on the instrument panel. If the switch is depressed, the system will perform one cycle of operation. The 24VDC timer will remain activated for the length of time indicated by the timer interval selector switch. ‰ Normal reading should be 18-26 VDC, depending upon whether or not the engine is running. Timer Adjustment The timer is factory set for a nominal 2.5 minute (off time) interval. Dwell time is approximately 1 minute, 15 seconds.
A longer interval (off time) is obtained by turning the Selector knob (3, Figure 42-7) to the desired position. Note: Actual switch location may vary depending on optional equipment installed on the truck. NOTE: Set timer by turning the Selector knob (3) to the 2.5 minute setting point. Then, turn the Selector clockwise, one detent at a time, to the desired setting, or until the maximum limit of eighty minutes is reached. FIGURE 42-6. MANUAL LUBE SWITCH The solid state timer is a sealed unit, do not attempt disassembly. 1. Instrument Panel 2. Manual Lube Switch 24 VDC Solid State Timer Check To check the timer operation without waiting for the normal timer setting, proceed as follows: 1.
Remove timer dust cover. NOTE: The timer incorporates a liquid and dust tight cover which must be in place and secured at all times during truck operation. 2. Adjust timer to the minimum time interval indi- cated on the timer faceplate. For example, set switch (3, Figure 42-7) for 2.5 minute interval using. 3. The timer should cycle in 2.5 minutes if the truck is operating. FIGURE 42-7. TIMER (TOP COVER REMOVED) NOTE: If the timer check is being made on a cold start, the first cycle will be approximately double the nominal setting. All subsequent cycles should be within the selected time tolerance. 1. Timer Case 2. Red LED (ON Indicator) 3. Timer Selector 4.
Voltage checks at the timer should be accom- plished if the above checks do not identify the problem. Refer to Figure 42-9 for an electrical circuit diagram. a. Insure timer ground connection is clean and tight. b. Using a Volt-Ohm meter, read the voltage between positive and negative posts on the solid state timer with the truck keyswitch ON.