Yamaha YFM7FGPW — PERIODIC MAINTENANCE AND MINOR REPAIR

8 18. When coolant begins to flow out of the bolt hole, tighten the cylinder head air bleed bolt to the specified torque. 19. Start the engine and let it idle for ten minutes. 20. Rev the engine five times. 21. Pour the recommended coolant into the radia- tor until it is full. Tightening torque: Cylinder head air bleed bolt: 10 Nm (1.0 m·kgf, 7.2 ft·lbf) 1. Cylinder head air bleed bolt 8-36 15. Remove panel E. (See page 8-8.) 16. Loosen the clamp screw, and then remove the V-belt cooling duct. 17. Loosen the cylinder head air bleed bolt, with- out removing it, to allow all of the air to escape from the air bleed bolt hole. Tightening torque: Water pump air bleed bolt:

10 Nm (1.0 m·kgf, 7.2 ft·lbf) 1. V-belt cooling duct 2. Clamp screw