Kaiyi BR380JG-1E0 — MEASURING CONTROL CIRCUIT BASIC PRESSURE

30 Testing and adjusting SEN02303-00 Measuring control circuit basic pressure 1 3. Install nipple [2] and oil pressure gauge [1] of hydraulic tester K1 . a Use the oil pressure gauge of 5.9 MPa {60 kg/cm 2 }. a Measuring tools for control circuit basic pres- sure k Stop the engine, loosen the oil filler cap of the hydraulic tank gradually to release the residual pressure from the hydraulic tank, and set the work equipment lock lever in the LOCK position. a Measure the control circuit basic pressure under the following condition. k Stop the machine on a level ground. q Hydraulic oil temperature: Within operating range 4. Start the engine. 5.

While running the engine at high idle, turn all the operation switches OFF and measure the oil pressure. 1. Disconnect inlet hose (1) of the 5-spool sole- noid valve. 6. After finishing measurement, remove the mea- suring tools and return the removed parts. a Do not adjust the relief valve for control circuit basic pressure. 2. Connect adapter K2 to hose (1) and install the hose again. BR380JG-1E0 29 Symbol Part No. Part name K 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 799-401-3100 Adapter: 02