SEN02303-00 30 Testing and adjusting Measuring and adjusting oil pressure in pump PC control circuit 1 a Measuring and adjusting tools for oil pressure in pump PC control circuit k Stop the machine on a level ground. k Stop the engine, loosen the oil filler cap of the hydraulic tank gradually to release the residual pressure from the hydraulic tank, and set the work equipment lock lever in the LOCK position. Measuring a Before measuring the oil pressure in the pump PC control circuit, check that the oil pressure in the work equipment and travel circuits and the basic pressure of the control circuit are normal.
a Measure the oil pressure in the pump PC con- trol circuit under the following condition. q Hydraulic oil temperature: Within operating range 2) Install nipple L2 and connect it to oil pres- sure gauge [1] of hydraulic tester L1 . a Use the oil pressure gauge of 58.8 MPa {600 kg/cm 2 }. 1. Measuring PC valve output pressure (servo piston inlet pressure) a Measure the PC valve output pressure (servo piston inlet pressure) and pump discharge pressure simultaneously and compare them. 1) Remove oil pressure pickup plugs (1), (2), (3), and (4). q (1): Front pump discharge pressure pickup plug q (2): Rear pump discharge pressure pickup plug q (3): Front PC valve output pressure pickup plug q (4):
Rear PC valve output pressure pickup plug 30 BR380JG-1E0 Symbol Part No. Part name L 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 799-101-5220 Nipple (10 × 1.25 mm) 07002-11023 O-ring