30 Testing and adjusting SEN02303-00 2. Measuring PC-EPC valve output pressure 1) Remove oil pressure pickup plug (5). 2) Install nipples L2 and connect them to oil pressure gauges [1] of hydraulic tester L1 . a Use the oil pressure gauges of 5.9 MPa {60 kg/cm 2 }. 3) Start the engine. 4) While running the engine at high idle, relieve the travel circuit and measure the pump discharge pressure and PC valve output pressure (servo piston inlet pres- sure) simultaneously. a Measuring condition and method of judgment: If the pressures are in the following ratio, the PC valve is nor- mal. 3) Start the engine.
4) Turn OFF all the work equipment switches, run the engine at high idle and low idle, and measure the oil pressure at each speed. a If the PC valve or the servo piston is abnormal, the PC valve output pres- sure (servo piston inlet pressure) is “the same as the pump discharge pressure” or “almost 0”. 5) After finishing measurement, remove the measuring tools and return the removed parts. BR380JG-1E0 31 Measured oil pressure Condition Ratio of oil pressures Pump discharge pressure Travel relief 1 PC valve output pressure Approx. 0.6 (Approx. 3/5)