Kaiyi BR380JG-1E0 — MEASURING AND ADJUSTING OIL PRESSURE IN PUMP LS CONTROL CIRCUIT

30 Testing and adjusting SEN02303-00 Measuring and adjusting oil pressure in pump LS control circuit 1 1. Measuring LS valve output pressure (servo piston inlet pressure) a Measure the LS valve output pressure (servo piston inlet pressure) and pump discharge pressure simultaneously and compare them. 1) Remove oil pressure pickup plugs (1), (2), (3), and (4). a Measuring and adjusting tools for oil pressure in pump LS control circuit q (1): Front pump discharge pressure pickup plug q (2): Rear pump discharge pressure pickup plug q (3): Front LS valve output pressure pickup plug k Stop the machine on a level ground.

k Stop the engine and loosen the oil filler cap of the hydraulic tank gradually to release the residual pressure from the hydraulic tank. q (4): Rear LS valve output pressure pickup plug Measuring a Before measuring the oil pressure in the pump LS control circuit, check that the oil pressure in the work equipment and travel circuits and the basic pressure of the control circuit are normal. a Measure the oil pressure in the pump LS con- trol circuit under the following condition. q Hydraulic oil temperature: Within operating range BR380JG-1E0 33 Symbol Part No.

Part name M 1 799-101-5002 Hydraulic tester 790-261-1204 Digital hydraulic tester 2 799-101-5220 Nipple (10 × 1.25 mm) 07002-11023 O-ring 3 799-401-2701 Differential pressure gauge