SEN02303-00 30 Testing and adjusting 2) Install nipple M2 and connect them to oil pressure gauge [1] of hydraulic tester M1 . a Use the oil pressure gauges of 58.8 MPa {600 kg/cm 2 }. 3) Start the engine. 4) While running the engine at high idle, measure the pump discharge pressure and LS valve output pressure (servo pis- ton inlet pressure) simultaneously under the condition in the following table. a Measuring condition and method of judgment: If the pressures are in the following ratio, the LS valve is normal. 5) After finishing measurement, remove the measuring tools and return the removed parts. 2.
Measuring LS differential pressure a Measure the pump discharge pressure and LS pressure (actuator load pressure) simultaneously and calculate the differ- ence between them. 1) Remove oil pressure pickup plugs (1), (2), (3), and (4). q (1): Front pump discharge pressure pickup plug q (2): Rear pump discharge pressure pickup plug 34 BR380JG-1E0 Measured oil pressure Condition Ratio of oil pressures All work equip- ment switches OFF All work equipment switches ON (No load) Pump discharge pressure Almost same 1 LS valve output pressure Approx. 0.6 (Approx. 3/5)