30 Testing and adjusting SEN02303-00 q (3): Front LS pressure pickup plug q The figure shows the LS pressure side. q (4): Rear LS pressure pickup plug 3) Run the engine. 4) While running the engine at high idle under the condition shown in the table, measure the pump discharge pressure and LS pressure (actuator load pressure) simultaneously. a Calculation of LS d ifferential pressure: LS differential pressure = Pump dis- charge pressure – LS pressure 2) Install nipple M2 and connect it to differen- tial pressure gauge M3 or the oil pressure gauge [1] of hydraulic tester M1 . a When using differential pressure gauge M3 :
Connect the pump discharge pres- sure to the high pressure side (back side) and connect the LS pressure to the low pressure side (lower side). Since the differential pressure gauge needs a 12V power source, connect it to a battery. a When using oil pressure gauge (in M1 ): Use the oil pressure gauge of 58.8 MPa {600 kg/cm 2 } having the unit of 0.98 MPa {10 kg/cm 2 }. Since the dif- ferential pressure is about 3.9 MPa {40 kg/cm 2 } at maximum, measure it by installing the same gauge to the pickup plugs alternately. 5) After finishing measurement, remove the measuring tools and return the removed parts. q The figure shows the pump discharge pressure side.
BR380JG-1E0 35 All work equipment switches LS differential pressure (MPa {kg/cm2}) OFF 3.9 ± 1.0 {40 ± 10} ON (No load) 0.98 ± 0.1 {10 ± 1.0}