SEN02304-00 30 Testing and adjusting 4) Engine speed holding function Pressing [ E ] switch while the engine operation on cylinder cut out screen is turned on holds the engine speed and its speed is newly displayed in the lower space. Pressing [ R ] switch during holding can- cels the holding function and deletes the display in the lower space. a If the holding function is used, the held speed is displayed in the lower space along with ( ) and the upper space continuously displays the cur- rent speed. a The holding function is usable inde- pendent of the currently set mode – the cylinder cut out or not. [Reference]:
Using the holding function effectively The engine speed being displayed on the screen through the holding function remains on it until the holding is cancelled. In other words, enabling or disabling of the cylinder cut out mode does not affect the display. Thus, when identifying a failed cylinder quicker, fol- lowing operation is effective. (1) Run the engine from the normal operation mode (no cylinder cut out) and then hold the speed of that time. (2) Specify the cylinder to be diagnosed as the cut out. (3) Run the engine under the same condition as that for (1). Then compare the engine speed at that time and the held speed being displayed to diagnose the cylinder.
(4) Reset a cut out cylinder independent of the fluctuations in the engine speed. (5) Repeat above steps (2) to (4) and then com- pare the results against that obtained from other cylinders. a If the diagnosis identified a cylinder on which there was no decrease in the engine speed or the decrease was small, it can be safely judged that there must be some abnormalities in its combustion. 30 BR380JG-1E0