30 Testing and adjusting SEN02305-01 Outlet clearance adjusting method When the machine is used continuously, wear of the addendum will cause the crusher outlet clear- ance to become larger, and the size of the particle will become coarser. If the crushed particles are remarkably worse than when the clearance was last adjusted, adjust the clearance as follows. The crusher outlet clearance is adjusted by extend- ing or retracting the lock cylinder. On this machine, there are three types of clearance adjustment function. A (Automatic): The clearance is automatically adjusted according to the set value input on the clearance set monitor. S (Semi-automatic):
The clearance is automatically adjusted by inputting the desired value for change on the clearance set moni- tor. (If the input value is (+), the clear- ance becomes larger; if the input value is (–), the clearance becomes smaller.) M (Manual): It is possible to adjust the clearance manually by using the panel switch. k Before starting operations, check that there is no one inside the crusher or in the sur- rounding area. k When the machine is shipped from the fac- tory, the clearance is set to 50 mm (O. S. S.), so adjust the discharge clearance to the desired size or size suitable for the material being crushed. k O. S. S.
means the condition when the crusher discharge clearance is fully opened. k Always be sure to check that the crusher chamber is empty and that there is no mud, sand, or soil stuck to the teeth. k Start the engine. For adjusting the outlet clearance, set the travel lever lock to the LOCK position without fail. k Be sure to attach a warning tag to the start- ing switch in the control box. k For starting the engine, see the sections of “Check before starting engine” and “Start- ing engine” in Operation of OPERATION in Operation and maintenance manual.
When adjusting the outlet clearance, use the inch- ing operation to bring the position of the flywheel to the center of the adjustment range on the right to position it before adjusting the outlet clearance. (A): Adjustment range (B): Flywheel marking (red painted part) BR380JG-1E0 5