30 Testing and adjusting SEN02305-01 a As [Normal] is indicated, proceed to the next step. a If [Abnormal] is indicated, repeat the procedure from step 1). a If [Network error] were displayed, check the indication of [LED-C4] ref- erencing “KOMTRAX terminal lamp indications”. (When CAN is not recog- nized, check KOMTRAX terminal CAN harness for troubles. If any, repair the trouble and repeat the pro- cedure from step 1)). 9) Set the starting switch to START position and maintain it in that state for 5 seconds. Make sure the engine is not started. a If the engine is started, repeat the procedure from step 1). 10) Return the starting switch to ON position and maintain that state for 5 seconds.
a Don't return it to OFF position. 11) Set the starting switch to START position again and make sure the engine is started. 12) Make sure that the KOMTRAX terminal 7- segment indicator lamps are normally turned on. Note: The third number on the display can be “2” or “3” though “3” is displayed in fig- ure below (both for the normal state and when trouble is present). a As [Normal] is confirmed, proceed to the next step (it will take 90 seconds to 15 minutes until normal display is restored). a If [GPS position data sensing error] were displayed, check the GPS antenna and cable for external trou- bles. If any, repair the trouble and repeat the procedure from step 1).
a If [Receiving error] were displayed, check the communication antenna and cable for external troubles. If any, repair the trouble and repeat the pro- cedure from step 1). a If [GPS position data sensing error and Receiving error] were displayed, check the GPS antenna and cable as well as the communication antenna and cable for external troubles. If any, repair the trouble and repeat the pro- cedure from step 1). BR380JG-1E0 51