30 Testing and adjusting SEN02305-01 4. KOMTRAX terminal Insert or connect troubleshooting T-adapter in or to connector G01 of KOMTRAX terminal (4). a The connectors are fixed with screws. Loosen the screws before disconnecting them. a When returning the connectors to their original positions, fix them by tightening the screws with the specified torque. 3 Screw: 2.82 Nm {0.288 kgm} a Cable (5) is used for the communication antenna (2 systems). a Cable (6) is used for the GPS antenna. a Removal and installation of sensor A deep socket is necessary for removal and installation of the engine oil pressure switch. See “Tools for testing, adjusting, and troubleshooting”. 6.
Boost pressure and temperature sensor (BOOST PRESS & IMT) a Disconnection and connection of con- nector The connector of the boost pressure and temperature sensor has a special locking mechanism. Disconnect it according to steps (a) – (b) and connect it according to steps (c) – (d) as shown below. Disconnection : (a) Unlock – (b) Discon- nect connector. Connection : (c) Connect connector – (d) Lock. 5.
Atmospheric pressure sensor (AMBAIR PRESSURE) Engine Ne speed sensor (CRANK SENSOR) Engine Bkup speed sensor (CAM SENSOR) Engine oil pressure switch (OIL PRESSURE SWITCH) a Disconnection and connection of con- nectors The connectors of the atmospheric pres- sure sensor, engine Ne speed sensor, engine Bkup speed sensor, engine oil pressure switch have a special locking mechanism. Disconnect them according to steps (a) – (c) and connect them according to steps (d) – (f) as shown below. Disconnection : (a) Slide lever – (b) Unlock – (c) Disconnect connector. Connection : (d) Connect connector – (e) Lock – (f) Slide lever.
a Removal and installation of sensor A torque wrench is necessary for removal and installation of the boost pressure and temperature sensor. See “Tools for test- ing, adjusting, and troubleshooting”. BR380JG-1E0 57