SEN02091-00 40 Troubleshooting Failure code [7RFCKA] Disconnection in magnetic separator solenoid 1 Related electrical circuit diagram 10 BR380JG-1E0 User code Failure code Trouble Disconnection in magnetic separator solenoid (Work equipment and pump controller (work equipment control) system) — 7RFCKA Contents of • trouble When the magnetic separator solenoid is driven, disconnection of the circuit is detected. • Action of • controller Turns the output to the magnetic separator solenoid OFF. Even if cause of failure disappears, system does not reset itself until engine starting switch is turned OFF. Problem that • appears on • machine The magnetic separator does not work.
Horn sounds (three intermittent sounding) upon detecting a failure. • Related • information • The driven state (ON/OFF) of the magnetic separator solenoid can be checked with the monitoring function (Code: 25500, Solenoid Valve) Since the controller detects the disconnection while the magnetic separator solenoid is driven, be sure to turn the solenoid output ON when checking reproduction of the failure after repair. The failure history is recorded.
1 Possible causes and standard value 2 in normal state 3 Cause Standard value in normal state/Remarks on troubleshooting Defective magnetic separator solenoid (Internal disconnec- tion) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. AV4 (male) Resistance Between (1) and (2) 20 – 60 z Disconnection in wiring harness (Disconnec- tion in wiring or defec- tive contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between C03 (female) (25) – AV4 (female) (2) Resistance Max.
1 z Defective work equip- ment and pump controller aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. C03 (female) Resistance Between (25) and chassis ground 20 – 60 z