40 Troubleshooting SEN02091-00 Failure code [7RJMMW] Lock cylinder slipping 1 BR380JG-1E0 45 User code Failure code Trouble Lock cylinder slipping (Work equipment and pump controller (work equipment control) system) — 7RJMMW Contents of trouble • Judges that the lock cylinder slips if the gap in the crusher is increased for more than the specified value during the crusher operation, compared with the gap amount when the switch is turned from "Check" to "Working". Action of controller • When a slip of lock cylinders is detected, the crusher and feeder automatically stop. • Sounds the horn for 5 sec. • Turns the red crusher monitor lamp on the machine monitor.
Problem that appears on machine • If machine is operated as it is, crusher may be damaged. Related information • If a foreign material such as mass of iron enters, the crusher is overloaded and lock cylinder slips for crusher protection in the crusher while the machine is operating properly. • The lock cylinder slip history can be checked with the SERVICE MENU on the machine monitor. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Abnormality in crusher clearance potentiome- ter system Troubleshoot based on failure code [7RENKZ].
2 Abnormality in lock cyl- inder unlock solenoid circuit system Troubleshoot based on failure code [7RFNKY]. 3 Abnormality in link of crusher clearance potentiometer Directly check for missing, deformation or other defects of parts at the potentiometer and link mounting section. 4 Internal defect of lock cylinders • The cylinder locking force may be dropped or insufficient. • If causes 1 – 3 are not detected, the lock cylinders may be defective.