Kaiyi BR380JG-1E0 — FAILURE CODE [CA441] POWER SOURCE VOLTAGE TOO LOW

SEN02093-00 40 Troubleshooting Failure code [CA441] Power source voltage too low 1 16 BR380JG-1E0 User code Failure code Trouble Power source voltage too low (Engine controller system) E10 CA441 Contents of trouble • There is low voltage in controller power supply circuit. Action of controller • None in particular. Problem that appears on machine • Engine stops. • Engine does not start easily. Related information • Method of reproducing failure code: Turn starting switch ON. Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Looseness or corro- sion of battery terminal Battery terminal may be loosened or corroded.

Check it directly. 2 Low battery voltage aPrepare with engine starting switch OFF, then keep engine starting switch OFF and start engine and carry out troubleshooting in each case. Battery (1 piece) Starting switch Voltage Between (+) – (–) terminals OFF Min. 12 V START Min. 6.2 V 3 Defective fuse No. 3 If fuse is broken, circuit probably has ground fault. (See Cause 6) 4 Defective relay for engine controller power supply aPrepare with engine starting switch OFF, then turn engine starting switch ON and carry out troubleshooting. Replace relay (R21, R22) for engine controller with another relay and per- form reproducing operation.

If “E” of failure code goes off at this time, replaced relay is defective. 5 Disconnection in wiring harness (Disconnec- tion in wiring or defec- tive contact in connector) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between B28 No.3 – R21, R22 (female) (3) Resistance Max. 10 z Wiring harness between R21, R22 (female) (5) – CE03 (female) (3) Resistance Max. 10 z Wiring harness between CE03 (female) (1) – chassis ground (T27) Resistance Max.

10 z 6 Ground fault in wiring harness (Short circuit with GND circuit) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between B28 No.3 – R21, R22 (female) (3) Resistance Min. 100 kz Wiring harness between R21, R22 (female) (5) – CE03 (female) (3) Resistance Max. 10 z 7 Short circuit in wiring harness (with another wiring harness) aPrepare with engine starting switch OFF, then carry out troubleshooting without turning engine starting switch ON. Wiring harness between CE03 (female) (3) – CE03 (female) (1) pin (with battery terminal dis- connected) Resistance Min.

100 kz Wiring harness between CE03 (female) (3) – each of CE02 (female) pins (With battery termi- nal disconnected) Resistance Min. 100 kz Wiring harness between CE03 (female) (1) – each of CE02 (female) pins (With battery termi- nal disconnected) Resistance Min. 100 kz