Kaiyi BR380JG-1E0 — TURNING OVER AND REPLACING FIXED JAW PLATE

SEN02738-00 50 Disassembly and assembly Turning over and replacing fixed jaw plate 1 4. Measure the clearance on each side of fixed jaw plate (3) and determine the point where the fixed jaw plate is aligned with the crusher frame. 1. Remove the cheek plates. See “Replacing cheek plates”. 5. Insert block (B) (wood block, etc.) between fixed jaw plate (3) and swing jaw plate (4). 2. Using the attached tools, remove fixed jaw plate wedge bolt (1) and fixed jaw plate wedge block (2). 6. Referring to the method of adjusting the clear- ance of discharge setting, push out swing jaw plate (4) to press fixed jaw plate (3) against the front frame. 3. Sling fixed jaw plate (3) with wires (A).

When turning over Lower fixed jaw plate (3) on a stand. Install the wires on the opposite side and insert the fixed jaw plate in the crusher frame. When replacing Remove fixed jaw plate (3) and install new one in the crusher frame. a After removeing the fixed jaw plate, remove all dirt and sand from the fixed jaw plate mounting faces (the front frame and the top of the fixed jaw plate mount stop- per). 7. Install the fixed jaw plate wedge and fixed jaw plate wedge bolt (5). a Length (L) of fixed jaw plate wedge bolt spring: 108 – 110 mm 8. Install the cheek plates. See “Replacing cheek plates”. 4 BR380JG-1E0