beckhoff TwinCAT 2 Motion — 2.3 Group Errors

Overview of NC Errors 2.3 Group Errors NC Errorcodes 14 Version: 1.1 Error(Hex) Error(Dec) Error type Description 4162 16738 Parameter Interpolation rules can not be determined The actual active interpolation rules (G-Code), zero offset shifts or rotation cannot be detected. 4170 16752 NC programming Error loading: invalid parameter The NC has found an invalid parameter while loading an NC program. 4171 16753 Internal Invalid contour start position The NC has detected a calculation error during processing: The specified contour cannot be calculated because the start position is not on the contour. 4172 16754 Internal Reverse:

invalid table index The NC encountered an invalid internal entry index during execution of the retrace function. 4173 16755 NC programming Invalid G code Invalid default G code. Wrong expression/syntax in the default G code. 4174 16756 NC programming Error opening the G code file Error opening the default G code file. Error(Hex) Error(Dec) Error type Description 4200 16896 Parameter Group ID not allowed The value for the group ID is not allowed, e.g. because it has already been assigned, is less than or equal to zero, or is greater than 255. Value range: [1 ... 255] Unit: 1 4201 16897 Parameter Group type not allowed The value for the group type is unacceptable because it is not defined.

Type 1: PTP group with slaves (servo) Type 4: DxD group with slaves (3D group) Type 5: fast/creep group Type 6: stepper motor group Type 9: encoder group with slaves (servo) … Value range: [1 ... 12] Unit: 1 4202 16898 Initialization Master axis index not allowed The value for the master axis index in an interpolating 3D group is not allowed, because, for instance, it has gone outside the value range. Index 0: x-axis (first master axis) Index 1: Y axis (second master axis) Index 2: Z axis (third master axis) Value range: [0, 1, 2] Unit:

1 4203 16899 Initialization Slave axis index not allowed (internal error) The value for the slave axis index in a group is not allowed, because, for instance, it has passed outside the value range, the slave location to be used when inserting a new slave connection is already occupied, or because no slave is present when such a connection is being removed.