beckhoff TwinCAT 2 Motion — 2.3 Group Errors

Overview of NC Errors NC Errorcodes 27 Version: 1.1 Error(Hex) Error(Dec) Error type Description The parameterized target velocity is lower than the minimum velocity (but the value zero is permitted). The value for minimum velocity is calculated from the minimum jerk rate and the NC cycle time (minimum jerk rate multiplied with the square of the NC cycle time). The unit for example is mm/s. 4287 17031 Monitoring Activation cannot be executed due to a pending activation A activation e.g. "CamIn", "CamScaling" or "WriteMotionFunction" cannot be executed due to a pending activation (e.g. "CamIn", "CamScaling", "WriteMotionFunction"). Only activation can be enabled.

4288 17032 Monitoring Illegal combination of different cycle times within an axis group Within a logical axis group, different cycle times have been detected for the common setpoint generation or for I/O processing of an axis. This situation can occur with Master/ Slave coupling or configuring 3D- and FIFO-groups (including path, auxiliary, and slave axes). 4289 17033 Monitoring Invalid axis motion reversal Due to the current dynamic state (current velocity, acceleration and jerk) a motion reversal would be caused. To avoid this motion reversal the axis command is not performed and the previous system state restored.

428A 17034 Monitoring Illegal command timing, because another instruction with future activation position is active The moment for the command is illegal because there is still an old command with activation position active (e.g. "go to new velocity at threshold position" or "reach new velocity at threshold position"). 428B 17035 Monitoring Stop-calculation routine (internal error) Due to an internal error in the stop-calculation routine the current commando cannot be performed. The previous system state is restored.

428C 17036 Monitoring A command with activation position cannot fully be performed because the remaining path is too short A command with activation position (threshold) like "reach a new velocity at a position" can be just partially executed because the path from the actual position to the activation position is too short. 428D 17037 Monitoring Invalid decouple type The command to release a slave coupling with subsequent restart command has been called with an invalid decoupling or restart type.

428E 17038 Monitoring Illegal target velocity when decoupling a slave axis The command to release a slave coupling with subsequent restart command has been called with an impermissible target velocity [1 428F 17039 Monitoring Activation new dynamic parameters cannot be performed The command to activate new dynamic parameters such as acceleration, deceleration and jerk cannot be executed, as this would require a new assigned travel velocity. This error situation can occur, for example, if the axis is close to the target position in the accelerated state and the dynamics parameters are reduced.