Overview of NC Errors NC Errorcodes 30 Version: 1.1 Error(Hex) Error(Dec) Error type Description 42A2 17058 Parameter Critical angle at segment transition not allowed The angle at the segment transition is not allowed. Value range: (0.0 ... 180.0] Unit: degrees 42A3 17059 Parameter Radius of the tolerance sphere The radius of the tolerance sphere is outside the permitted range of values. Value range: [0.0 ... 100.0] Unit: e.g. mm 42A4 17060 Parameter Reserved Reserved, currently not used. 42A5 17061 Parameter Start type Value range: [0.1] Unit: 1 42A6 17062 Parameter Reserved Reserved, currently not used. 42A7 17063 Parameter Blending Blending is not possible with the given parameters.
42A8 17064 Parameter Reserved Reserved, currently not used. 42A9 17065 Parameter Curve velocity reduction method not allowed (internal error) The curve velocity reduction method does not exist. 42AA 17066 Parameter Minimum velocity not allowed The minimum velocity that has been entered is less than 0.0. 42AB 17067 Parameter Power function input not allowed (internal error) The input parameters in the power () function lead to an _ FPU exception. 42AC 17068 Parameter Dynamic change parameter not allowed A parameter that regulates the change of dynamics is invalid. Parameter: 1.Absolute path dynamics change: all parameters must be strictly positive. 2.Relative reduction c f:
0.0 42AD 17069 Memory Memory allocation error (internal error) An error occurred during memory allocation. 42AE 17070 Function End position (internal error). The calculated end position differs from the end position in the NC block 42AF 17071 Parameter Calculate remaining path length invalid value Value range: [0,1] 42B0 17072 Function Setpoint generator SPP active Starting the setpoint generator (SPP, SEC) has been refused, since the SPP task is already active. 42B1 17073 Parameter SPP parameter not allowed (internal error) A parameter related to the internal structure of the setpoint generator (SPP) results in logical errors and/or to an FPU exception. Affects these parameters:
Minimum velocity (>0.0), TimeMode, ModeDyn, ModeGeo, StartType, DistanceToEnd, TBallRadius.