beckhoff TwinCAT 2 Motion — 2.3 Group Errors

Overview of NC Errors NC Errorcodes 33 Version: 1.1 Error(Hex) Error(Dec) Error type Description Filter parameter is not allowed. 42D4 17108 Function Residual distance deletion not possible. Delete Distance to go (only interpolation) failed. This error occurred, if e.g. the command 'DelDTG' was not programmed in the actual movement of the NC program.

42D5 17109 Internal The setpoint generator of the flying saw generates incompatible values (internal error) 42D6 17110 Function Axis will be stopped since otherwise it will overrun its target position (old PTP setpoint generator) If, for example, in case of a slave to master transformation for the new master a target position is commanded that will be overrun because of the actual dynamics the axis will be stopped internally to guarantee that the target position will not be overrun.

42D7 17111 Function Internal error in the transformation from slave to master 42D8 17112 Function Wrong direction in the transformation of slave to master 42DA 17114 Parameter Parameters of Motion Function (MF) table incorrect The parameters of the Motion Function (MF) are invalid. This may refer to the first time created data set or to online changed data. 42DB 17115 Parameter Parameters of Motion Function (MF) table incorrect The parameters of the Motion Function (MF) are invalid. This can refer to the data set created for the first time or to data changed online. The cause of the error may be that, for example, an active MF point (i.e.

not an IGNORE point) points to a passive MF point (i.e. IGNORE point). 42DC 17116 Monitoring Internal error by using Motion Function (MF) An internal error occurs by using the Function (MF). This error cannot be solved by the user. Please ask the TwinCAT Support. 42DD 17117 Function Axis coupling with synchronization generator declined because of incorrect axis dynamic values The axis coupling with the synchronization generator has been declined, because one of the slave dynamic parameter (machine data) is incorrect.

Either the maximum velocity, the acceleration, the deceleration or the jerk is smaller or equal to zero, or the expected synchronous velocity of the slave axis is higher as the maximum allowed slave velocity. 42DE 17118 Function Coupling conditions of synchronization generator not allowed If the direction of travel of the master axis is positive, the master synchronous position must be greater than the master coupling position ("i.e. lie in the future"). With negative master travel direction, the master synchronous position must be smaller than the master coupling position.

42DF 17119 Monitoring Motion profile of synchronization generator declines dynamic limit of slave axis or required characteristic of profile