beckhoff TwinCAT 2 Motion — 2.3 Group Errors

Overview of NC Errors NC Errorcodes 35 Version: 1.1 Error(Hex) Error(Dec) Error type Description 42ED 17133 Parameter Internal error GROUPERR FIFO INVALIDDIMENSIO _ _ The FIFO dimension (number of axes) has been increased from 8 to 16 from TC 2.11 Build 1547. Value range: [1 ... 8] resp. [1 ... 16] Unit: 1 (number of axes) 42EE 17134 Address Internal error GROUPERR ADDR FIFOTABLE _ _ 42EF 17135 Monitoring Axis is locked for motion commands because a stop command is still active The axis/group is locked for motion commands because a stop command is still active.

This lock can be released by calling the stop command with Execute=FALSE or by an axis reset (see also MC Stop and MC Reset in _ _ TcMC2.Lib). 42F0 17136 Parameter Invalid number of auxiliary axes The local number of auxiliary axes does not tally with the global number of auxiliary axes. 42F1 17137 Parameter Invalid reduction parameter for auxiliary axes The velocity reduction parameters for the auxiliary axes are inconsistent. 42F2 17138 Parameter Invalid dynamic parameter for auxiliary axes The dynamic parameters for the auxiliary axes are inconsistent. 42F3 17139 Parameter Invalid coupling parameter for auxiliary axes The coupling parameters for the auxiliary axes are inconsistent.

42F4 17140 Parameter Invalid auxiliary axis entry The auxiliary axis entry is empty (no axis motion). 42F6 17142 Parameter Invalid parameter The limit for velocity reduction of the auxiliary axes is invalid. It has to be in the interval 0..1.0. 42F8 17144 Parameter BlockSearch - segment not found The segment specified as parameter could not be found until the end of the NC program. Possible cause:

- nBlockId is not specified in the mode described by eBlockSearchMode 42F9 17145 Parameter Blocksearch - Invalid remaining segment length The remaining distance in the fLength parameter is incorrectly parameterized 42FB 17147 Internal Internal error in connection with coupled axes (slave axes) Internal fatal error when using coupled axes (slave axes). Inconsistent internal state. Please contact our Support. 42FC 17148 Parameter Parameter for maximum number of jobs (entries) to be transferred is invalid The parameter describing the maximum number of entries to be transferred from the SPP to the SEC table per NC cycle is invalid. Value range: [1 20] Unit:

1 42FF 17151 Monitoring Customer-specific error