Overview of NC Errors NC Errorcodes 43 Version: 1.1 Error(Hex) Error(Dec) Error type Description 435E 17246 Monitoring Looping distance smaller than braking distance The absolute value of the looping distance is less or equal than the positive or negative braking distance. This is not allowed. 435F 17247 Monitoring Starting velocity not allowed The required starting velocity for a positioning task is not allowed (normally the starting velocity is zero). This can happen if the velocity is less than or equal to zero, larger than the maximum permitted axis velocity, or, in the case of servo drives, is larger than the reference velocity of the axis (see axis and drive parameters).
4360 17248 Monitoring Final velocity not allowed The required final velocity for a positioning task is not allowed (normally the final velocity is zero). This can happen if the velocity is less than or equal to zero, larger than the maximum permitted axis velocity, or, in the case of servo drives, is larger than the reference velocity of the axis (see axis and drive parameters). 4361 17249 Monitoring Time range exceeded (future) The calculated position lies too far in the future (e.g. when converting a position value in a DC timestamp). 4362 17250 Monitoring Time range exceeded (past) The calculated position lies too far in the past (e.g. when converting a position value in a DC timestamp).
4363 17251 Monitoring Position cannot be determined The requested position cannot be determined mathematically because a) it has never been reached in the past or b) it will never be reached in the future (e.g. if the axis velocity is zero or if a reversal of motion occurs due to an acceleration). 4364 17252 Monitoring "Position indeterminable (conflicting direction of travel)" The direction of travel expected by the caller of the function deviates from the actual direction of travel (conflict between PLC and NC view, for example when converting a position to a DC time). 4370 17264 Monitoring No slave coupling possible (velocity violation) A slave coupling to a master axis (e.g.
by a universal flying saw) is rejected because otherwise the maximum velocity of the slave axis would be exceeded (a velocity monitoring has been selected). 4371 17265 Monitoring No slave coupling possible (acceleration violation) A slave coupling to a master axis (e.g. by a universal flying saw) is rejected, because otherwise the maximum acceleration of the slave axis will be exceeded (an acceleration monitoring is selected). 4372 - 438B 17266 - 17291 See TF5055 NC Flying Saw - Error Codes 43A0 17312 Internal Axis consequential error Consequential error resulting from another causative error related to another axis.
Axis consequential errors can occur in relation to master/slave-couplings or with multiple axis interpolating DXD groups.