beckhoff TwinCAT 2 Motion — 2.6 Controller Errors

Overview of NC Errors NC Errorcodes 54 Version: 1.1 Error(Hex) Error(Dec) Error type Description 4504 17668 Parameter Lag error monitor (position) not allowed The value for the activation of the lag error monitor is not allowed. Value range: [0, 1] Unit: 1 4505 17669 Parameter Lag monitoring (velocity) not allowed The value for the activation of the lag error monitoring (velocity) is not allowed. Value range: [0, 1] Unit: 1 4506 17670 Parameter Lag error window (position) not allowed The value for the lag error window (maximum allowable lag error) is not allowed. Value range: [0.0, 10000.0] Unit: e.g.

mm 4507 17671 Parameter Lag error filter time (position) not allowed The value for the lag error filter time (position) is not allowed. Value range: [0.0, 600.0] Unit: s 4508 17672 Parameter Lag error window (velocity) not allowed The value for the lag error window (velocity) is not allowed. Value range: [0.0, 10000.0] Unit: e.g. m/min 4509 17673 Parameter Lag error filter time (velocity) not allowed The value for the lag error filter time (velocity) is not allowed. Value range: [0.0, 600.0] Unit: s 450A 17674 Parameter Controller output limitation (output limitation) not allowed The value for the output limitation of the controller at the total manipulated variable is invalid.

The default setting is 0.5 (50 percent). Typically, this parameter is effective if the velocity interface has been parameterized for the drive unit and the NC executes the position control of the position on the controller. Value range: [0.0, 1.0] Unit: %