Overview of NC Errors NC Errorcodes 59 Version: 1.1 Error(Hex) Error(Dec) Error type Description 452C 17708 Parameter Velocity observer: 'Amplitude damping d for 2nd order filter' is not allowed The high-pass/low-pass amplitude attenuation d or d for the 2nd order HP TP velocity filter ("bi-quad") of the velocity observer of the special NC controller in the torque interface is not allowed. Value range: [0.2 .. 10.0] Unit: 1 452D 17709 Parameter Velocity observer:
'Frequency fHP or fTP for 2nd order filter' is not allowed The high-pass/low-pass frequency f or HP f for the 2nd order velocity filter ("bi- TP quad") of the velocity observer of the special NC controller in the torque interface is not allowed. Value range: [0.0, ... 10000.0] Unit: Hz 4540 17728 Initialization Controller initialization The controller has not been initialized. Although the controller has been created, the rest of the initialization has not been performed (1. Initialization of controller, 2. Reset of controller). 4541 17729 Address Axis address The controller does not know its axis, or the axis address has not been initialized.
4542 17730 Address Drive address The controller does not know its drive, or the drive address has not been initialized. 4550 17744 Monitoring Lag error monitor (position) While the lag error monitor was active (position), the lag error was exceeded by an amount greater than the lag error window and which lasting longer than the parameterized lag error filter time. 4551 17745 Monitoring Lag monitoring (velocity) With active lag error monitoring (velocity) a velocity lag error exceedance has occurred, whose magnitude is greater than the lag error window, and whose duration is longer than the parameterized lag error filter time.
45A0 17824 Monitoring Internal error CONTROLERR RANGE AREA ASID _ _ _ E 45A1 17825 Monitoring Internal error CONTROLERR RANGE AREA BSID _ _ _ E 45A2 17826 Monitoring Internal error CONTROLERR RANGE QNENN _ _