beckhoff TwinCAT 2 Motion — 2.9 NC-PLC Errors

Overview of NC Errors NC Errorcodes 72 Version: 1.1 Error(Hex) Error(dec) Error type Description The type of a cam plate does not match the definition MC TableType. _ 4B36 19254 Parameter Number of rows invalid The number of rows (interpolation points) of a cam plate is less than 1. 4B37 19255 Parameter Number of columns invalid The number of columns of a cam plate is invalid. • The number of columns of a motion function is not equal 1 • The number of columns of a standard cam plate is not equal 2 • The number of columns does not match another parameter (ValueSelectMask) 4B38 19256 Parameter Step size invalid The step size for the interpolation is invalid, e.g. less than or equal to zero.

Error numbers 0x4B0F, 0x4B40 .. 0x4B4F are used in several libraries (TcNc-Lib / Tc2 MC2 XFC-Lib): _ _ 4B40 19264 Monitoring Terminal type not supported The terminal used is not supported by this function block. 4B41 19265 Monitoring Register read/write error This error implies a validity error. 4B42 19266 Monitoring Axis is enabled The axis is enabled but should not be enabled for this process.

4B43 19267 Parameter Incorrect size of the compensation table The specified table size (in bytes) does not match the actual size 4B44 19268 Parameter Positional deviation The minimum/maximum position in the compensation table does not match the position in the table description (ST CompensationDesc) _ 4B45 19269 Parameter Not implemented The requested function is not implemented in this combination 4B46 19270 Parameter Window not in the specified modulo range The parameterized min or max position is not in the specified modulo range 4B47 19271 Monitoring Buffer overflow The number of events has led to an overflow of the buffer and not all events could be acquired. Error numbers 0x4B50 ..

0x4B5F are used in the TcMcCam-Lib : Error numbers 0x4B60 .. 0x4B6F are used in the TcMc2-Lib in the buffered commands context: 4B60 19296 Monitoring Motion command did not become active A motion command has been started and has been buffered and confirmed by the NC. Nevertheless, the motion command did not become active (possibly due to a termination condition or an internal NC error). 4B61 19297 Monitoring Motion command could not be monitored by the PLC A motion command has been started and has been buffered and confirmed by the NC. The PLC has not been able to monitor the execution of this command and the