Overview of NC Errors NC Errorcodes 73 Version: 1.1 Error(Hex) Error(dec) Error type Description execution status is unclear since the NC is already executing a more recent command. The execution state is unclear. This error may come up with very short buffered motion commands which are executed during one PLC cycle. 4B62 19298 Monitoring Buffered command was terminated with an error A buffered command was terminated with an error. The error number is not available, because a new command is already being executed. 4B63 19299 Monitoring Buffered command was completed without feedback A buffered command was completed but there was no feedback to indicate success or failure.
4B64 19300 Monitoring 'BufferMode' is not supported by the command The 'BufferMode' is not supported by this command. 4B65 19301 Monitoring Command number is zero The command number for queued commands managed by the system unexpectedly has the value 0. 4B66 19302 Monitoring Function block was not called cyclically The function block was not called cyclically. The command execution could not be monitored by the PLC, because the NC was already executing a subsequent command. The execution state is unclear. Error numbers 0x4B70 .. 0x4B8F are used in the TcPlcInterpolation-Lib :
4B71 19313 Parameter Invalid NCI entry type The FB FB NciFeedTablePreparation was called with an _ unknown nEntryType. 4B72 19314 Function NCI feed table full The table is full and therefore the entry is not accepted. Remedy: Transfer the contents to the NC kernel with the FB FB NciFeedTable. If bFeedingDone = TRUE, the table _ can be reset in FB NciFeedTablePreparation with _ bResetTable and then filled with new entries. 4B73 19315 Function Internal error 4B74 19316 Parameter ST NciTangentialFollowingDesc: Tangential axis is _ not an auxiliary axis The entry for tangential following contains a tangential axis that is not an auxiliary axis.
4B75 19317 Parameter ST NciTangentialFollowingDesc _ nPathAxis1 or nPathAxis2 is not a path axis. It is therefore not possible to determine the plane. 4B76 19318 Parameter ST NciTangentialFollwoingDesc _ nPathAxis1 and nPathAxis2 are the same. It is therefore not possible to determine the plane. 4B77 19319 Parameter ST NciGeoCirclePlane _ Circle incorrectly parameterized 4B78 19320 Function Internal error An internal error has occurred in the calculation of the tangential following. 4B79 19321 Monitoring Tangential following