beckhoff TwinCAT 2 Motion — 2.9 NC-PLC Errors

Overview of NC Errors NC Errorcodes 75 Version: 1.1 Error(Hex) Error(dec) Error type Description 4B9F 19359 Cancellation of a homing The abortion of a homing has failed. Error numbers 0x4BA0 .. 0x4BAF are used in the TcNcKinematicTransformation-Lib : 4BA0 19360 Function KinGroup error The kinematic group is in an error state. This error may occur if the kinematic group is in an error state or an unexpected state when it is called (e.g., simultaneous call via several FB instances). 4BA1 19361 Function KinGroup timeout Timeout during call of a kinematic block Error numbers 0x4BB0 .. 0x4BBF are used in the Tc2 MC2 Drive-Lib :

_ _ 4BB0 19376 Function Invalid axis position The current axis position or the axis position resulting from the new position offset exceeds the valid range of values. 4BB1 19377 Function Invalid position offset The new position offset exceeds the valid range of values [AX5000: 2^31]. 4BB2 19378 Function Invalid axis position The current axis position or the axis position resulting from the new position offset falls below the valid range of values. 4BB3 19379 Function Invalid position offset The new position offset falls below the valid range of values [AX5000: -2^31].

4BB4 19380 Function Deviation of the activated feedback and/or storage location The activated feedback and/or storage location (AX5000: P-0-0275) differ from the parameterization on the function block. 4BB5 19381 Function Reinitialization of the NC actual position has failed The reinitialization of the actual NC position has failed, e.g., reference system = "ABSOLUTE (with single overflow)" & software end position monitoring is disabled. 4BB6 19382 Function The setting or deletion of a position offset was rejected The command to set or delete a position offset was rejected without feedback data, e.g., if the drive controller's firmware does not support the corresponding command.

4BB7 19383 Function The setting or deletion of a position offset was rejected The command to set or delete a position offset was rejected with feedback data. The information in the feedback data may contain further clues to the cause, e.g. if the firmware of the drive controller does not support the corresponding command. 4BB8 19384 Function Invalid firmware version A firmware version >= 19 is required for the servo terminal. 4BB9 19385 Function Deviating modulo settings