beckhoff TwinCAT 2 Motion — 2.12 Further Error Codes

Overview of NC Errors NC Errorcodes 81 Version: 1.1 Error(Hex) Error(Dec) ErrorType Description 0x8166 33126 Function Block Invalid parameter for GapControlMode. Invalid parameter for GapControlMode, most likely in combination with the group parameter GapControlDirection. 0x8167 33127 External Group got unsupported Axis Event (e.g. State Change). Group got unsupported Axis Event (e.g. State Change e.g. triggered by a Single Axis Reset). 0x8168 33128 Parameter Unsupported Compensation Type. The compensation type was either not set or is not supported by the addressed object. 0x8169 33129 Function Block Master axis does not exist or cannot be used.

0x816a 33130 External Invalid or Missing Tracking Transformation. This error occurs at MC TrackConveyorBelt if at the _ CoordTransform input an invalid object ID is used or the object ID points to an object that is not supported as coordinate transformation. 0x816b 33131 Function Block Position is not on Track. Either Track cannot be activated because Actual Position is not on Track, or Target Position is not on Active Track or TrackPart. 0x816c 33132 Function Block Axis does not have an activated track. 0x816d 33133 NC Programmin g Invalid Compensation ObjectId. An Object with this ObjectId does not exist or it is not of the right type (has to be a compensation).

0x816e 33134 Monitoring Axis is in error because axis was not in Target when InTargetAlarm Timer expired. 0x816f 33135 State Coupling would cause a cyclic dependency of axis (e.g. via MC GearInPos). _ 0x8170 33136 Function Block Axis was not added to an axes group, the command is not valid. 0x817f 33151 State Drive has invalid State. 0x8181 33153 Function Block Parameter for gap control are invalid with the current configuration. Function block with gap control was issued to an axis that is not in a CA group. 0x8182 33154 Monitoring Software position limit violation. Software position limits of at least one axis have been or would have been violated by a command.

0x8183 33155 NC Programmin g Target position is not reachable. There is no path available to the target position or target position is unreachable in general. 0x8185 33157 NC Programmin g The mover or one of its relevant coordinates is busy. Either the whole mover or at least of its coordinates relevant to the command are busy. 0x8186 33158 NC Programmin g A collision has occurred or would occur. Either a collision has occurred or would occur if the command was executed. 0x8187 33159 NC Programmin g Invalid Track Specification. The geometric extension of this track is incompatible with the already existing geometry of this or the other tracks.

0x8188 33160 NC Programmin g Command not allowed in track state. 0x8189 33161 Function Block Invalid Reference passed to Function Block. An invalid reference (or pointer) was used in a function block call. This can happen if a reference type is used before it was initialized.