Chapter 2: Installation Watch Dog Enable/Disable Watch Dog is a system monitor that can re- boot the system when a software application hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate a non-maskable interrupt signal for the appli- cation that hangs. See the table on the right for jumper settings. Watch Dog must also be enabled in the BIOS. ( Note: When enabled, the user needs to write his/her own applica- tion software to disable the WD Timer.) IEEE 1394a Enable JPI1 allows the user to use the onboard IEEE 1394_1 and 1394_2 connections. Close Pins 1 and 2 of this jumper to use this feature. See the table on the right for jumper settings.
The default setting is Enabled. VGA COM1 2-25 Watch Dog Jumper Settings (JWD) Jumper Setting Definition Pins 1-2 Reset (default) Pins 2-3 NMI Open Disabled 1394a Enable Jumper Settings Pin# Definition 1-2 Enabled (default) 2-3 Disabled 2Mouse JPKB W/ CPU Fan Fan1 CPU HDMI SPDIF_Out DIMM1A DIMM1B USB/0/1USB2/3/4/5 Fan5 Intel LAN1 JPUSB1 G45 (C2SEA) G43 (C2SEE) AUDIO DIMM1 DIMM2 HD Slot7 PCI-E x1 C2SEA/C2SEE JPL1 Slot6 PCI-E Gen2 x16 SPI BIOS CLTaRnL Slot5 PCI 33MHZ CMOS CLEAR In IC FP Audio Slot4 PCI-E x4 on x16 Slot3 PCI 33MHz Battery JPAC JI2C1 JI2C2 JD1 S I/O CD1 Slot2 PCI 33MHz SPKR1JPD1 B JPI1 IDE Slot1 PCI 33MHz JWOL CTR JL1 Printer JWOR Floopy 1394_11394_2 A. Watch Dog Enable B.
1394 1/1394 2 Enable _ _ DIMM2A DIMM2B JPW1 DIMM3 DIMM4 Fan2 LE1Fan3 tel JLED H10 JF1 JWD I-SATA0JOA H I-SATA4 I-SATA1 I-SATA5 I-SATA2 USB 10/11 I-SATA3 L USB 8/9 JPUSB2 USB6 USB7 IDE Fan4