cisco — Configuring OSPF Support for BFD over IPv4 for One or More Interfaces

Configuring OSPF Support for BFD over IPv4 for One or More Interfaces To configure BFD on one or more OSPF interfaces, perform the steps in this section. Procedure Configuring Bidirectional Forwarding Detection Configuring OSPF Support for BFD over IPv4 for One or More Interfaces Command or Action Purpose Step 1 enable Example: Device>enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device#configure terminal Enters global configuration mode. Step 3 interface type number Example: Device(config)#interface fastethernet 6/0 Enters interface configuration mode. Step 4 ip ospf bfd [disable] Example:

Device(config-if)#ip ospf bfd Enables or disables BFD on a per-interface basis for one or more interfaces that are associated with the OSPF routing process. Note Use the disable keyword only if you enable BFD on all the interfaces that OSPF is associated with using the bfd all-interfaces command in router configuration mode. Step 5 end Example: Device(config-if)#end Exits interface configuration mode and returns the device to privileged EXEC mode. Step 6 show bfd neighbors [details] Example: Device#show bfd neighbors details (Optional) Displays information that can help verify if the BFD neighbor is active and displays the routing protocols that BFD has registered.

Note If hardware-offloaded BFD sessions are configured with Tx and Rx intervals that are not multiples of 50 ms, the hardware intervals are changed. However, output from the show bfd neighbors details command displays only the configured intervals, not the interval values that change. Configuring Bidirectional Forwarding Detection 15