Configuring BFD Support for HSRP Perform this task to enable BFD support for Hot Standby Router Protocol (HSRP.) Repeat the steps in this procedure for each interface over which you want to run BFD sessions to HSRP peers. HSRP supports BFD by default. If HSRP support for BFD has been manually disabled, you can reenable it at the device level to enable BFD support globally for all interfaces or on a per-interface basis at the interface level. Before you begin • HSRP must be running on all participating devices. • Cisco Express Forwarding must be enabled.
Procedure Configuring Bidirectional Forwarding Detection Configuring BFD Support for HSRP Command or Action Purpose Step 7 show ip ospf Example: Device#show ip ospf (Optional) Displays information that can help verify if BFD support for OSPF has been enabled. Command or Action Purpose Step 1 enable Example: Device>enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device#configure terminal Enters global configuration mode. Step 3 ip cef [distributed] Example: Device(config)#ip cef Enables Cisco Express Forwarding or distributed Cisco Express Forwarding. Step 4 interface type number Example:
Device(config)#interface FastEthernet 6/0 Enters interface configuration mode. Step 5 ip address ip-address mask Example: Configures an IP address for the interface. Configuring Bidirectional Forwarding Detection 16