Configuring BFD Support for Static Routing Perform this task to configure BFD support for static routing. Repeat the steps in this procedure on each BFD neighbor. For more information, see the "Example: Configuring BFD Support for Static Routing" section. Procedure Configuring Bidirectional Forwarding Detection Configuring BFD Support for Static Routing Command or Action Purpose Device(config-if)#ip address 10.1.0.22 255.255.0.0 Step 6 standby [group-number] ip [ip-address [secondary]] Example: Device(config-if)#standby 1 ip 10.0.0.11 Activates HSRP. Step 7 standby bfd Example: Device(config-if)#standby bfd (Optional) Enables HSRP support for BFD on the interface. Step 8 exit Example:
Device(config-if)#exit Exits interface configuration mode. Step 9 standby bfd all-interfaces Example: Device(config)#standby bfd all-interfaces (Optional) Enables HSRP support for BFD on all interfaces. Step 10 exit Example: Device(config)#exit Exits global configuration mode. Step 11 show standby neighbors Example: Device#show standby neighbors (Optional) Displays information about HSRP support for BFD. Command or Action Purpose Step 1 enable Example: Enables privileged EXEC mode. Enter your password if prompted. Configuring Bidirectional Forwarding Detection 17