cisco — Configuring BFD Support for Static Routing

Configuring Bidirectional Forwarding Detection Configuring BFD Support for Static Routing Command or Action Purpose Device>enable Step 2 configure terminal Example: Device#configure terminal Enters global configuration mode. Step 3 interface type number Example: Device(config)#interface TenGigabitEthernet1/0/1 Configures an interface and enters interface configuration mode. Step 4 Perform one of the following steps: • ip address ipv4-address mask • ipv6 address ipv6-address/mask Example: Configuring an IPv4 address for the interface: Device(config-if)#ip address 10.10.10.1 255.255.255.0 Configuring an IPv6 address for the interface:

Device(config-if)#ipv6 address 2001:db8:1:1::1/32 Configures an IP address for the interface. Step 5 bfd interval milliseconds mix rx _ milliseconds multiplier interval-multiplier Example: Device(config-if)#bfd interval 500 min rx 500 multiplier 5 _ Enables BFD on the interface. The bfd interval configuration is removed when the subinterface on which it is configured is removed. The bfd interval configuration is not removed when: • an IPv4 address is removed from an interface • an IPv6 address is removed from an interface • IPv6 is disabled from an interface. • an interface is shutdown • IPv4 CEF is disabled globally or locally on an interface.

• IPv6 CEF is disabled globally or locally on an interface. Configuring Bidirectional Forwarding Detection 18