Procedure Configuring the Device to Use Vendor-Specific RADIUS Attributes Follow these steps to configure vendor-specific RADIUS attributes: Configuring RADIUS Configuring the Device to Use Vendor-Specific RADIUS Attributes Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 radius server server name Example: Device(config)# radius server rsim Specifies the name for the RADIUS server configuration for Protected Access Credential (PAC) provisioning, and enters RADIUS server configuration mode.
Step 4 key string Example: Device(config-radius-server)# key your server key _ _ Specifies the shared secret text string used between the switch and all RADIUS servers. Note The key is a text string that must match the encryption key used on the RADIUS server. Leading spaces are ignored, but spaces within and at the end of the key are used. If you use spaces in your key, do not enclose the key in quotation marks unless the quotation marks are part of the key. Step 5 retransmit retries Example: Device(config-radius-server)# retransmit 5 Specifies the number of times the switch sends each RADIUS request to the server before giving up. The default is 3; the range 1 to 1000.
Step 6 timeout seconds Example: Device(config-radius-server)# timeout 3 Specifies the number of seconds a switch waits for a reply to a RADIUS request before resending the request. The default is 5 seconds; the range is 1 to 1000. Step 7 end Example: Device(config-radius-server)# end Exits RADIUS server configuration mode and enters privileged EXEC mode. Configuring RADIUS 32