Chapter3 Handling Modifying the Media Size Setting The length (l) and gap between labels (g) set in the driver will be used repeatedly when compiling the data. Therefore, measuring multiple label positions that are actually used and setting the average value in the driver may improve the print position. l g Label print position of data compiled using the high speed batch label printing function Label affixing position on the actual media used L1 g G1 L2 g G2 L3 g G3 L4 g G4 Check it following the procedure below. 1 Measure the label length of the actual media used [e.g.: L1, L2, L3, L4] and gap between labels [e.g.: G1, G2, G3, G4].
This applies to cases where the distance from the tip of the first label is up to 400 mm (15.75 inches). 2 Calculate the average measured label length [e.g.: L=(L1+L2+L3+L4)/4] and the average gap between labels [e.g.: G=(G1+G2+G3+G4)/4]. 3 Check if the calculated average label length L of the actual media and the label length l of the printer driver match. If they do not match, enter the length L for the label length in the driver. 135 l l l l W i fi ithin 400 mm (15.75 nches) from the tip of the rst label