Chapter3 Handling 4 Check if the calculated average gap between labels G of the actual media and the gap between labels g of the printer driver match. If they do not match, enter the gap G for the gap between labels in the driver. If the shift of the print start position does not improve after performing the above procedure, perform the following procedure. "Checking How the Print Start Position is Shifted" on page 136 Checking How the Print Start Position is Shifted If there is a regularity in the shift of the print start position, such as when the shift increases by 1 mm (0.04 inches) per label, perform the following procedure.
"Checking the Gap Between Labels" on page 137 If there is no regularity, the label position may be unevenly distributed. In this case, the high speed batch label printing function cannot be used. Investigate improving the accuracy of the media you are using. Label print position of data compiled using the high speed batch label printing function Regular shift Irregular shift Within 400 mm (15.75 inches) from the tip of the first label Paper feed direction Paper feed direction Paper feed direction Distance shifted by the second label x = a Distance shifted by the third label x ≠ 2 Ч a Distance shifted by the fourth label x ≠ 3 Ч a a:
Distance shifted between the tip of the second label in the compiled data and the tip position of the second label on the media actually used x: Distance shifted between the tip of the n th label in the compiled data and the tip position of the n th label on the media actually used 136 Tip position of the second label in the compiled data Distance shifted by the second label x = a Tip position of the third label in the compiled data Distance shifted by the third label x = 2 × a Tip position of the fourth label in the compiled data Distance shifted by the fourth label x = 3 × a