Chapter3 Handling Cleaning the Edge Guides If labels, paper dust, or adhesive has adhered to the edge guides, paper may get jammed, or printing position may become incorrect. Clean the edge guides following the procedure below. • Do not use benzine, thinner, trichloroethylene, or ketone based solvent. Doing so may deform or damage the plastic and rubber parts. • Do not spray or allow alcohol to drip directly on the printer. If alcohol gets inside the printer, it may short-circuit the electronic components or cause deterioration or damage to the components. • After cleaning, wipe with a dry cloth so that no alcohol remains on the surface.
• Do not connect the power plug or operate the power supply until the alcohol has completely dried. CAUTION 1 Turn off the printer, and unplug the power cable. 2 Open the paper cover. If paper has been loaded, remove it. ( "How to Remove Paper (For the Auto Cutter Model)" on page 66 , "How to Remove Paper (For the Peeler Model)" on page 68 ) 3 Clean the edge guides using a cotton swab moistened with alcohol. 303