Chapter 3 Creating and Editing Screens 3.8.2.1 Set / Reset / Maintained / Momentary Buttons After pressing these buttons, HMI will transmit ON/OFF signal to PLC or the controller. There are four types of buttons: Set button, Reset button, Maintained and Momentary buttons. Please refer to the following table 3-8-2 for the property description of these four general buttons. Table 3-8-2 3-94 Revision May, 2010 Button Type Macro Read Write Function Enter Password O X X After pressing this button, the user can enter the password. Contrast Brightness O X X After pressing this button, the user can adjust the contrast brightness of HMI.
Low Security O X X Press this button one time to change the user security level to the lowest level (LEVEL 0). System Menu O X X Press this button one time to switch to the HMI system menu. Report List O X X After pressing this button, the screen data can be output to the designated location. The user can use is function to print out the screen data. Screen Capture O X X After pressing this button, the screen data can be captured and output to USB disk. The file output designation is located on USB disk. If a USB disk is not connected, the captured data cannot be output by HMI successfully. Remove Storage O X X The user can press this button to remove the USB disk safely.
Import/Export Recipe O X X Press this button to import or export the recipe data in CSV Excel format from or into external memory. Calibration O X X The user can press this button to perform calibration function. Language Changer O X X The user can press this button to change the display language. Property Description of General Buttons Write Address Read Address The address can be internal memory, internal parameter or the controller address. If only the write address is set, HMI will read the value of the write address automatically.
Pressing button next to the “Write Address” or “Read Address” the user will enter into the following “Input” dialog box and select the write address or the read address.