Chapter 3 Creating and Editing Screens Revision May, 2010 3-229 Control Block tab in Configuration option Auto Reset Flag If the Auto Reset Flag box is checked, the register in the control block is cleared to 0 when any operation is finished in the control block. Status Address Use to set the starting address of system status block. The length is constant 8 words. Each word indicates the different status value of HMI system. For more detailed information of system status block, refer to section 3.4. COM Port tab in Configuration option Add/ Delete/ Modify Add Press Add button to determine the connecting device name and the controller. Please refer to the figure below:
Available connecting PLC will be different depending on HMI type. (DOP-B series HMI can support up to three different controllers simultaneously.)